Audi Q2 GA 1.5 TFSI Front Wheel Carrier Hub Bearing Right O/S 5Q0407256S

Audi Q2 GA 1.5 TFSI Front Wheel Carrier Hub Bearing Right O/S is an original suspension component designed for the front-wheel-drive axle. This complete wheel bearing assembly ensures stable handling, precise geometry maintenance, and secure seating of the hub with the bearing, which translates into safe vehicle road behavior. This used OEM component is a sensible choice for drivers looking for a proven, factory-spec solution at an attractive price.

Specifications and technical data

• SKU: 5Q0407256S
• Mark: Audi
• Condition: Used
• OEM Part Number: 5Q0407256S
• Substitutable numbers: 5Q0407256S, 5Q0 407 256 S, 5Q0400054RS, 5Q0 400 054 RS
• Location on the vehicle: Front, Right
• Category: Wheel Bearings, Hubs & Seals

Purpose and function in the suspension system

The wheel carrier with hub and bearing for the front right side is responsible for the rigid connection between the wheel and the suspension, as well as interacting with steering and braking system components. In practice, this means:

• maintaining the correct wheel position relative to the body and suspension,
• stable support of the hub and bearing under front axle loads,
• transferring forces from the steering system to the wheel,
• cooperation with brake caliper and disc mounting points.

As a result, this assembly is crucial for handling precision, driving comfort, and braking efficiency, especially in front-wheel-drive vehicles such as the Audi Q2 GA 1.5 TFSI.

Benefits of using an original Audi component

The original wheel carrier with hub and bearing from the Wheel bearings, hubs, and bushings group has been designed specifically for the Audi Q2 GA suspension geometry. This ensures:

• factory-fit compatibility with shock absorber, control arm, and tie rod mounts,
• correct hub positioning relative to sensors and brake system components,
• preservation of wheel geometry parameters specified by the manufacturer,
• reduced risk of improper tire and suspension component wear.

Choosing an original component helps avoid problems typical of aftermarket parts with inaccurate dimensions, which is particularly important in modern front suspension designs.

Installation and operational characteristics

The complete front right wheel carrier assembly with hub and bearing simplifies service work – the mechanic receives a ready-to-install wheel support component that can be fitted in place of a worn or damaged part. This configuration promotes:

• shorter repair time compared to replacing individual components,
• maintaining the structural integrity of the entire wheel assembly,
• easier condition monitoring during periodic inspections.

After installation, it is recommended to perform a wheel alignment to fully utilize the potential of the newly installed component and ensure stable vehicle handling across the entire speed range.

A conscious choice of a used OEM component

A used OEM component for Audi is a solution that allows you to balance cost control with factory-grade build quality. For many drivers, this is a way to restore full suspension performance without the need to invest in expensive new parts. If you want to better understand how to safely use the secondary market and what to look for when buying, read the article Used car parts: Myths and facts you need to know, which dispels the most common doubts associated with such products.

Expansion and modernization of the wheel system in Audi

If you are planning a comprehensive repair or modernization of the wheel and suspension area in your Audi and need other elements from the same group, such as additional hubs, bearings, or mounting bushings, check out the available parts in the Audi wheel bearings, hubs, and bushings category.