BMW F40 F44 Bonnet Hood Seal Gasket Rubber Right O/S Side 7476910

BMW F40 F44 Bonnet Hood Seal Gasket Rubber Right O/S Side is an original body component from the Seals and Gaskets group, designed for installation on the right side of the engine bay. It ensures a tight seal for the bonnet, limits the ingress of water and contaminants, and supports proper aerodynamics of the bonnet edge.

Specifications and technical data

• SKU: 7476910
• Mark: BMW (Genuine OE)
• Condition: Used
• OEM Part Number: 7476910
• Substitutable numbers: 7476910, 51767476910
• Location on the vehicle: Right
• Category: Gaskets & Seals

Purpose and function of the BMW F40/F44 bonnet seal

The presented seal is dedicated to BMW F40 and F44 series models and operates on the right side of the vehicle, along the edge of the bonnet. Its task is to provide a stable seal at the bonnet-to-body interface, which limits air drafts, the penetration of moisture, and fine debris into the engine compartment.

Thanks to a properly selected rubber profile, this component helps maintain even pressure on the bonnet, reduces unwanted edge vibrations, and can contribute to reducing wind noise in the front section of the bodywork.

Construction and material properties

The seal is made of flexible rubber material, designed to operate in varying temperature conditions and under constant exposure to atmospheric factors. The cross-sectional profile has been matched to the geometry of the BMW F40/F44 bonnet edge, which facilitates installation and ensures stable seating on factory mounting points.

The original BMW origin ensures the maintenance of factory dimensional tolerances, which translates into proper fitment with the bonnet and fenders, as well as compatibility with other sealing elements of the front body section.

Vehicle placement and installation

The component is intended for installation on the right side of the vehicle, along the edge of the bonnet. Correct placement is crucial for maintaining the continuity of the sealing line and even pressure of the bonnet against the body.

In most cases, installation involves seating the seal in factory guides or clips, without the need for body modifications. It is recommended to check the condition of the mating surfaces and other bonnet seals to ensure the consistent operation of the entire sealing system.

Benefits of using an original BMW seal

• Improved sealing of the bonnet and body contact point on the right side.
• Limitation of water, dirt, and dust ingress into the engine compartment.
• Stable fitment thanks to factory geometry and build quality.
• Support for maintaining proper aerodynamics of the front of the vehicle.
• Compatibility with factory mounting points in the BMW F40/F44.

Condition and service application

The seal comes from disassembly and is offered as a used part, which is a cost-effective solution for accident repairs, replacing worn sealing elements, or restoring factory bonnet alignment after hinge and latch adjustments. Choosing an original BMW component allows for maintaining material and structural consistency with other body parts.

Expansion of the BMW sealing zone

If you are planning a comprehensive repair or upgrade of the body sealing zone in your BMW and need other elements from the same group, such as additional bonnet seals, door seals, or gaskets, check out the available parts in the BMW Seals and Gaskets category.

To better plan service work within the body and auxiliary systems, it is also worth checking out the guide on the air conditioning system – you will find practical tips in the article A/C Compressor – symptoms of failure, causes, and safe replacement, which helps assess when replacing a used component is the right solution.