BMW F10 F11 LCI N55 Rear Axle Right O/S Output Drive Shaft Driveshaft 7581024

BMW F10 F11 LCI N55 Rear Axle Right O/S Output Drive Shaft Driveshaft is an original drivetrain component designed for installation on the rear axle on the passenger side. Thanks to its factory BMW design, it ensures precise fitment to the suspension geometry and stable drivetrain operation under demanding operating conditions.

Specifications and technical data

• SKU: 7581024
• Mark: BMW (Genuine OE)
• Condition: Used
• OEM Part Number: 7581024
• Substitutable numbers: 7581024, 33207581024, 8603098, 33208603098, 0253141687134B
• Location on the vehicle: Rear, Right
• Fuel type: Diesel
• Part type: Driveshaft
• Category: Driveshafts

Purpose and compatibility

The presented driveshaft is dedicated to BMW 5 Series F10/F11 LCI (facelift) models with a diesel engine. The component operates on the rear axle, on the right side, and is responsible for transferring torque from the final drive to the wheel hub. This positioning requires appropriate torsional rigidity and resistance to variable loads resulting from suspension and drivetrain operation.

The original BMW design ensures the maintenance of the correct working length, joint operating angles, and compatibility with factory mounts and the hub, which facilitates installation and reduces the risk of improper component fitment.

Construction and performance parameters

This type of driveshaft consists of a half-shaft with joints that compensate for suspension movement and load changes during acceleration and engine braking. Constant velocity (CV) joints ensure smooth torque transfer without vibrations or jerking, which translates into driving comfort and reduced stress on other drivetrain components.

The component has been designed to work with a diesel engine, which generates high torque at low RPMs. This requires adequate fatigue strength and resistance to overloads, especially during dynamic driving and frequent use of the engine's full potential.

Condition, origin, and advantages of using a used part

The offered driveshaft comes from disassembly and is marked as a used part. For many BMW users, this represents a favorable compromise between cost and quality – an original aftermarket component retains factory design parameters while allowing for cost savings compared to a new part from an authorized dealership.

Using an original driveshaft from disassembly helps maintain the integrity of the entire drivetrain, minimizing the risk of issues with balancing, play, or improper joint operation that may occur with low-quality components from uncertain sources.

Benefits of proper driveshaft replacement

A functional BMW F10 F11 LCI N55 Rear Axle Right O/S Output Drive Shaft Driveshaft contributes to:

• reducing vibrations and knocking sounds coming from the rear axle during acceleration and deceleration,
• stable torque transfer to the wheel, without jerking or delayed response,
• reducing loads acting on the differential, hubs, and suspension components,
• more predictable vehicle behavior at higher speeds and under load.

Replacing a worn driveshaft with a functional component of this type is particularly important in high-mileage vehicles, those operated on poor-quality road surfaces, or those used intensively for long-distance driving.

Technical support and additional materials

When planning work within the drivetrain, it is worth paying attention to the condition of the clutch, dual-mass flywheel, and other drivetrain elements. Helpful information regarding diagnostics and component selection can be found in the article: Clutch and dual-mass flywheel – diagnostics and selection of drivetrain parts.

If you are planning a comprehensive repair or upgrade of the drivetrain area in your BMW and need other elements from the same group, such as half-shafts, joints, or complete drivetrain components, check the available parts in the BMW driveshafts category.