Audi RS6 C7 Front Axle Driveshaft Left Right N/O/S Drive Shaft 4G0407271F

Audi RS6 C7 Front Axle Driveshaft Left Right N/O/S Drive Shaft is a component from the Driveshafts group, designed for operation on the front axle on either the left or right side of the Audi drivetrain. This used OEM part ensures factory geometry, proper torque transmission, and compatibility with the factory suspension and drivetrain, which facilitates servicing and reduces the risk of installation issues.

Specifications and technical data

• SKU: 4G0407271F
• Mark: Audi
• Condition: Used
• OEM Part Number: 4G0407271F
• Substitutable numbers: 4G0407271F, 4G0 407 271 F
• Location on the vehicle: Front, Left, Right
• Category: Driveshafts

Purpose and vehicle placement

The presented front driveshaft is designed for installation in the front axle area of the Audi RS6 C7, with the possibility of application on the left or right side. Such placement in the vehicle allows for direct power transmission from the transmission to the wheel hub, maintaining proper operation of the running gear and stability during acceleration and braking.

Thanks to the factory design, the joint geometry and driveshaft length are adapted to the specific dynamic loads of the RS6 C7 version, which is significant given the higher power and torque outputs characteristic of this model.

Benefits of using an original Audi driveshaft

Choosing an original component from the Audi Driveshafts group primarily ensures compliance with the vehicle's factory parameters. This includes:

• secure fitment to the wheel hub and transmission,
• proper cooperation with the suspension and steering system,
• maintenance of the drivetrain operating characteristics intended by the manufacturer.

Using a pre-owned OEM component allows for reduced repair costs while maintaining high material and construction quality, which is particularly important in high-performance vehicles.

Condition, installation, and service application

The item is offered as a used Audi driveshaft, which in practice means it has been removed from a vehicle and is intended for further use after proper installation. Due to the preservation of the original design, it can be installed in place of the factory driveshaft without the need for modifying other components.

This solution works well both for standard replacement of a worn driveshaft and for repairs following mechanical damage within the front axle area. Properly matching the part to the specific RS6 C7 version helps reduce vibrations, unwanted noises, and excessive wear of joints and tires.

Technical support and part selection

When selecting a driveshaft for an Audi, it is worth paying attention to compatibility with the body version, drivetrain, and placement on the vehicle. In case of doubt, it is helpful to compare the component's design with the currently installed part and verify compatibility based on manufacturer data.

If you are planning a comprehensive repair or upgrade of the drivetrain area in your Audi and need other elements from the same group, such as additional driveshafts, intermediate shafts, or power transmission components, check the available parts in the Audi Driveshafts category.

More about drivetrain repairs and part selection

When working on the drivetrain, especially in high-power cars, it is worth consciously choosing OEM components. A guide explaining why used original parts often represent a more favorable alternative to unreliable replacements may be helpful – more information can be found in the article Humming differential? Find out why a used OEM drive axle is a better investment than an uncertain replacement.

If you are considering whether a new replacement or a used original part is the better solution in your case, comparing costs and quality described in the material New or used? A comparison of car part costs and quality may also be helpful.